![]() If after you have attempted this a couple of times and it will not stay cleared just silence the alarm and call our office at 70. If your alarm does not go back into alarm after a minute or two then it should be fine, if it goes back off repeat step 3.Wireless smokes are a little different, they are covered in another FAQ. Once you are sure that the air is clear then go to your keypad and type in the following “*7” this will reset the alarm as well as your smoke detector(s).Wait at least 30 min to allow and smoke to clear the chamber even after you can’t see or smell the smoke, it can. Clear ALL the smoke out of the area where the smoke detector in question is.If you want it to stop flashing immediately, do a power cycle, i.e.: Power the panel down by unplugging the battery and the transformer to put the Panel to sleep wait a minute, then plug in the transformer and battery, in that order. Remember to put you alarm on test for at least an hour, this will allow time for you to try and correct the problem. If you do nothing, the system with self-test within the next day and the Power light will stop flashing. If the monitoring service has not yet called, if your system is monitored, please call them and advise that it is a false alarm and they will attempt to cancel the fire department.This means typing in your code just like you were disarming the system. If the power light is off, there is no AC power. Go to Security Command Center On the Organization drop-down list, select the organization that you want to enable Security Command Center. If, however, you have “burnt the popcorn” and set off one of your smoke detectors do the following. Code is entered followed by the CANCEL key during or after an alarm report to the central station. Go to Security Command Center in the Google Cloud console. First off please make sure that there is really NO FIRE that is causing the alarm to go off, if you have any doubts please wait until the fire department shows up and let them check for you.
0 Comments
Leave a Reply. |